How the greenhouse on US cars has evolved from the late-40s to present

1957 Oldsmobile

(UPDATED FROM 3/1/2020)

Greenhouses have not typically changed as frequently as other parts of the American automobile’s external styling, but they go a long way toward summing up the dominant design approach of a given era.

The greenhouse is the part of the car body above the beltline that includes the roof, pillars and glass. The structure of this area is so integral to the vehicle that it cannot be changed as easily as front or rear styling. Major changes in a car’s greenhouse have thus mostly occurred when bodies were substantially or completely redesigned.

Fastbacks gave way to notchbacks in the early-50s

Packard offers a good example of the evolution of American car design away from streamlining. The 1948 models were dramatically reskinned from pre-war models but kept the same semi-fastback roofline. Then in 1951 the body was completely redesigned; this included a notchback roofline and substantially more glass area (go here for further discussion).

For 1955 the Packard body was given new front and rear sheetmetal but carried over the roofline except for a new wrap-around windshield (go here).

1948 Packard Super

1951 Packard 300 was a predecessor to the 1956 Packard Executive
1948 (top) and 1951 Packard

As the 1950s progressed, greenhouses got lower, longer and wider — much like the rest of American cars. One of the key victims was the hat, which you could no longer wear inside a car because of reduced headroom.

It’s hard to overstate how quickly the basic shape of the American car changed in the 1950s. As a case in point, compare the 1957 Oldsmobile shown at the top of the post with the 1953 Plymouth below. The Plymouth was arguably the last of the “old school” designs that did not sacrifice interior room for stylishness (go here for further discussion).

1953 Plymouth
1953 Plymouth

Curved side glass made greenhouses less boxy

Up through the late-50s side window glass was always flat. The 1957 Imperial was the first mass-produced American car that switched to curved side windows. This design trend swept the industry to the point that by 1966 the only American-made passenger cars which still had flat side glass were the Chevrolet Chevy II, the Checker and the Canadian-built Studebaker.

In theory, curved greenhouse sides could increase a car interior’s width by reducing the thickness of doors. That proved to be the case with the 1963-66 Rambler but not the 1961-63 Lincoln Continental. The Rambler was five inches narrower but had the same amount of hip room as the Continental (Consumer Reports, 1963).

1964 Rambler Classic two-door hardtop

1963 Lincoln Continental
1964 Rambler (top) and 1963 Lincoln Continental

Since we are talking about the 1961-63 Continental, it would be worth mentioning that this was the granddaddy of the contemporary four-door coupe (go here for further discussion). In the photograph below, notice how the C-pillar is pushed unusually far forward — which was typical for a two-door hardtop of that era.

Also note that the upper-part of the rear door opening was so small that entry and exit would have been much more challenging if Lincoln had not used forward-opening rear doors.

1963 Lincoln Continental
1963 Lincoln Continental

In the 1960s fastbacks returned — with mixed results

Fastbacks have only recently become the dominant greenhouse design for passenger cars. In the last half of the 20th Century they were largely relegated to sporty coupes and economy hatchbacks.

Part of the problem was that automakers sometimes struggled to get the proportions right. The 1965-66 Rambler Marlin is the poster child for a vaguely interesting design idea gone terribly wrong.

1965 Rambler Marlin rear quarter
1965 Rambler Marlin 

Two-door models were more rapidly changed

From the 1960s through the 1970s, the greenhouses of two-door body styles tended to receive more frequent redesigns because they were viewed as style leaders.

Perhaps the best example of quickly shifting styling trends was Chevrolet’s full-sized two-door hardtop. Within a 16-year time span General Motors’ designers gave this body style seven different looks.

The 1961 Impala is fairly representative of the dominant look of that time period — a rounded semi-fastback with lots of glass area.

1961 Chevrolet Impala
1961 Chevrolet Impala (Old Car Advertisements)

From 1962 to 1964 the Chevrolet — along with its corporate siblings Pontiac, Oldsmobile and Buick — switched to a notchback roof design that was shaped like a convertible. Given that the two-door hardtop body style originally morphed from the convertible, it’s surprising that this approach wasn’t used more often.

1963 Chevrolet Impala
1963 Chevrolet Impala (Old Car Advertisements)

For 1965 GM drifted back to a semi-fastback roofline. However, GM’s was more curvaceous than the hardtops offered by Ford, Chrysler and American Motors.

1965 Chevrolet Impala
1965 Chevrolet Impala (Old Car Brochures)

When GM reskinned its full-sized cars for 1967-68, the two-door hardtop curved even more seamlessly into the back deck. That required a different trunk lid than was used on the sedans because it curved upward into the C-pillar.

1968 Chevrolet Impala
1968 Chevrolet Impala (Old Car Brochures)

For 1969, swoopy was out and the brougham look was in. All of GM’s full-sized cars received notchback rooflines, often wearing vinyl roofs. Chevrolet had anticipated this trend in 1966, when its top-of-line Caprice two-door hardtop was first given a “brougham-style” notchback roofline not shared with its corporate siblings.

1969 Chevrolet Caprice
1969 Chevrolet Caprice (Old Car Brochures)

The notchback stuck around through the rest of the 1970s, although in 1975 GM switched from a pillarless design to one that had large B-pillars and “opera windows.”

1976 Chevrolet Caprice
1976 Chevrolet Caprice (Old Car Brochures)

When GM downsized its big cars in 1977, weight was saved by discontinuing hardtop body styles in favor of pillared sedans. That gave the 1978 Chevrolet Impala pictured below a more utilitarian look. Perhaps GM didn’t care because buyers of two-door models now gravitated toward mid-sized “personal coupes” such as the Monte Carlo, which continued to use frameless door glass.

1978 Chevrolet Impala
1978 Chevrolet Impala (Old Car Advertisements)

American greenhouses looked starkly different in 1970s

Passenger cars tended to get lower up until Detroit started to downsize its automotive fleet in the late-70s and early-80s. Height reductions mostly occurred in the greenhouse. That resulted in a turret-topped look to some cars.

A case in point was Chrysler’s 1969-73 full-sized cars, which had a relatively high beltline and a low roofline for two-door hardtops. The 1970 Chrysler New Yorker shown below looks particularly out of proportion (go here for further discussion).

1970 Chrysler New Yorker
1970 Chrysler New Yorker (Old Car Brochures)

From the 1950s through the 1970s, imported cars provided a strong counterpoint to U.S. automobile design. Emblematic of the time was the Mercedes-Benz W123, which emphasized function over form. That included an unusually tall greenhouse, narrow C-pillars for better rearward-visibility, exposed windshield wipers and thick frames around doors.

1970s Mercedes-Benz W123
Circa late-70s Mercedes-Benz W123 sedan

Boxy designs of 1980s give way to aerodynamic shapes

The first half of the 1980s were noteworthy for the extreme boxiness of cars in general and greenhouses in particular. The success of more streamlined designs such as the 1986 Ford Taurus resulted in a gradual shift back to more rounded greenhouses.

By the 2010s even more conservative sedans adopted sharply sloping windshields and semi-fastback rooflines. Typical of this trend was the Infiniti G37 and G50.

2013 Infiniti G37
2013 Infiniti G37

Along the way there were some deviations from the norm. For example, The 2004 Chrysler 300C had an unusually boxy greenhouse. This did not help aerodynamics — or styling, for that matter — so its reskinned successor in 2011 reverted to a more sharply raked A-pillar (go here for further discussion).

2004 Chrysler 300C

2011 Chrysler 300C side
First- and second-generation Chrysler 300C

Less glass area has given greenhouses a less airy look

The 300C is also notable for the squished look of its greenhouse. The intent was presumably to give the car a more sinister look.

Tightening side-impact regulations have also served to reduce the amount of glass area in cars and trucks. As a case in point, the 2018 Ford Expedition looks like it was sat on by the Green Giant.

2018 Ford Expedition
2018 Ford Expedition

Does the future belong to ‘one-box’ greenhouse shapes?

Smaller cars have increasingly integrated the hood line with the greenhouse to improve aerodynamics as well as space efficiency. For example, the Honda Fit has been a disciple of this “one-box” approach. This may very well become the dominant greenhouse shape as tighter emissions regulations put a heavier premium on aerodynamics.

2015 Honda Fit
2015 Honda Fit

NOTES:

This is an updated version of a story that was originally posted on March 1, 2020.


RE:SOURCES

  • Consumer Reports; 1963. “Basic Body Dimensions.” Published April; p. 165.

ADVERTISING & BROCHURES:

Society of Automotive Historians gives Indie Auto an award

Be the first to comment

Leave a Reply

Your email address will not be published.


*